Getting sound from vkeyboard

studio32 · Post by **studio32** » Wed Aug 06, 2008 8:57 am

What do you connect exactly in te audio , midi and alsa widget/tab when you use jack keyboard with qsynth?

In midi I've:

jack-keyboard | jackkeyboard
midi out midi in
system: system:
-midi capture 1 midi playback 1 (and 2,3,4,5)
-midi capture 2

brummer · Post by **brummer** » Wed Aug 06, 2008 9:16 am

yeh, two of this midi_playback_out ports are qsynth, that you have to figure out by connect them and launch if you can hear a sound ore watch the light in qsynth, when you press a key, if you found them you can rename them by a right click with your mouse, after that you will find them easy next time you wont to use this connection.
This way you can also figure out what the other ports are and give them the names you wont to identifier them esay.
The screanschot is my jack-midi-connect widget with the renamings.

brummer
and again sorry for my bad english . . . .

studio32 · Post by **studio32** » Wed Aug 06, 2008 10:53 am

sorry no sound here yet

I can rename it now, I had to set that option in qjackctl settings...

brummer · Post by **brummer** » Wed Aug 06, 2008 11:16 am

sorry no sound here yet

so when you open the qjackctl midi widget and the system entry, and start then qsynth, dont there pop up new entry's ?

have'nt you enable in the qjackctl setup "Enable Alsa sequencer support"

ups, I dont think on that

studio32 · Post by **studio32** » Wed Aug 06, 2008 6:35 pm

I've enabled alsa sequencer, still no sound

:/

brummer · Post by **brummer** » Thu Aug 07, 2008 5:06 am

enabled it in "Settings > mididriver > seq " and in "misc > Enable Alsa Sequencer support" ?

studio32 · Post by **studio32** » Thu Aug 07, 2008 9:47 am

brummer wrote:enabled it in "Settings > mididriver > seq " and in "misc > Enable Alsa Sequencer support" ?

yes, did that... mmh maybe I have time today to try it again...