LinuxMusicians

This is my first post, forgive me if it this not the right place

I am struggling to connect a Casiotone CT-S300 keyboard for MIDI play and record trough USB in Manjaro 22.0 with XFCE. I have tried Audacity and Reaper but the device it is not detected. QjackCtl is installed.

The output of lsusb:

Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 001 Device 004: ID 2232:1080 Silicon Motion Web Camera
Bus 001 Device 003: ID 0bda:0129 Realtek Semiconductor Corp. RTS5129 Card Reader Controller
Bus 001 Device 005: ID 248a:8514 Maxxter Wireless Receiver
Bus 001 Device 002: ID 1a40:0101 Terminus Technology Inc. Hub
Bus 001 Device 006: ID 8087:0aaa Intel Corp. Bluetooth 9460/9560 Jefferson Peak (JfP)
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

Any help is appreciated!

Try starting from when the Casio is not connected, and run the following in a terminal:

$ sudo dmesg -w

That will begin "tailing" the dmesg output in the terminal. Leave it running, and plug the Casio into the USB slot. What output appears?

tseaver wrote: ↑Tue Dec 27, 2022 3:31 am

Try starting from when the Casio is not connected, and run the following in a terminal:

Code: Select all

$ sudo dmesg -w

That will begin "tailing" the dmesg output in the terminal. Leave it running, and plug the Casio into the USB slot. What output appears?

Thank you very much, I repeated this procedure until realizing the problem was a defective cable.

@juancho

Thank you very much, I repeated this procedure until realizing the problem was a defective cable.

I'm glad to be your "rubber ducky"[1] here.

[1] https://en.wikipedia.org/wiki/Rubber_duck_debugging

Tres.