LinuxMusicians

I'm trying to set up my MPD32 with Ardour and have a midi map installed that I found online but I'm coming across an odd problem. If I move a fader or knob on my controller too quickly then the parameter it is controlling in Ardour stops moving, if I move it slowly again then it works continuously. I don't know this is Ardour or my controller or some other set up issue but I never experienced this in Windows so I assume I can rule out the controller itself.

I am using Also Sequencer set in Jack and Alsa midi bridge running in Cadence.

Is there anything in particular that might cause this to happen?

Turns out it was the smoothing parameter when double clicking on the generic control surface, changed it from 10 to 80 and I can move it as fast as I like.