Hello all,
I have bought a Behringer FCB1010 Midi footswitch, and I try to use ripwerxcom under linux debian-based distribution (LibraZik), but any success...
I tried it in Win10 (dualboot) with JRE environnement, and it's working fine...
The firmware version in the FCB1010 is a 5.2 official (not a UNO eprom), and the riperwxcom version I used is the 1.8 (older version that works with official Behringer firmware...)
Have you any suggestion, please ?
Thanks in advance...
FCB1010 and ripwerxcom
Moderators: MattKingUSA, khz
Re: FCB1010 and ripwerxcom
I remember it took me quite a bit of fiddling to figure out the correct midi connections. Are you sure you have the midi connected correctly?
I have the UNO mod though and haven't messed with it in quite a while so I'm not sure I'll be much help.
I have the UNO mod though and haven't messed with it in quite a while so I'm not sure I'll be much help.
_ssj71
music: https://soundcloud.com/ssj71
My plugins are Infamous! http://ssj71.github.io/infamousPlugins
I just want to get back to making music!
music: https://soundcloud.com/ssj71
My plugins are Infamous! http://ssj71.github.io/infamousPlugins
I just want to get back to making music!
Re: FCB1010 and ripwerxcom
Hello,
thanks for this reply...
About hardware midi connections I think it's ok because as I have said, it's ok with Win10, and Midi connections are the same...
thanks for this reply...
About hardware midi connections I think it's ok because as I have said, it's ok with Win10, and Midi connections are the same...
Re: FCB1010 and ripwerxcom
I mean more the software midi setup, rather than hardware. Dunno if that helps at all.
_ssj71
music: https://soundcloud.com/ssj71
My plugins are Infamous! http://ssj71.github.io/infamousPlugins
I just want to get back to making music!
music: https://soundcloud.com/ssj71
My plugins are Infamous! http://ssj71.github.io/infamousPlugins
I just want to get back to making music!