I have a home studio solution set up where I have a certain amount of hardware instruments hooked up to my computer, as well as a hardware MIDI sequencer to control all these devices, which is also connected to my computer via USB. I use Cadence to manage my Jack connections, and it works great. I establish the MIDI connections from my sequencer, and all is good:
I have all of my equipment hooked up to the same power supply, and turn all the gear off when I don't use it, except the computer. When I turn everything on again, both Cadence and Jack is still running, and the devices show up. The connections I made, however are lost, and I have to reconnect them again.
Now, it's not really that many reconnections to make, but it's still a bit of a drag, especially when the software connections are persistent when I stop and start the apps. Is there any way to make the hardware MIDI connections persist as well?
What other apps and distros do you use to round out your studio?
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest