Scarlett 2i2

[hellalive]

I own one too and my settings are almost the same. I would check connections or other minor issues (monitoring knob on the interface ecc); in jack I had to set duplex and select the Scarlett for both input and output otherwise it would output via my onboard card. Hope this helps

[voodoosound]

Hi,

jack only runs at 48kHz with 512 Frames and higher.
Non realtime, no memory restriction, Duplex,...

No playback, just capture.

[hellalive]

sorry for the delay, been busy. I think this could be a kernell issue; I suggest you to try kernel 3.5.xx and see if it gets better.

[voodoosound]

Hi,
the error was between chair and monitor. As most of the time...

I switched on direct monitoring and turn up the big wheel... was not what I expected, instead -> feedback (Mic feed into Speaker)

I switched direct monitoring off again and turned the big wheel down...

I did not come to the conclusion, that this big wheel also adjusts the line level...

stupid me

but perhaps someone else can learn from my stupidity...

[hellalive]

but what about jack setings? i can run like at 44100/64 with a lowlatency kernel on my machine