Qtractor - automate modwheel and pitchwheel

Support & discussion regarding DAWs and MIDI sequencers.

Moderators: khz, MattKingUSA

thebutant
Established Member
Posts: 135
Joined: Sun Nov 18, 2012 12:59 pm

Qtractor - automate modwheel and pitchwheel

Postby thebutant » Wed Mar 27, 2019 10:40 am

I feel a bit stupid for asking about this, as I think there's some basic knowledge that I've missed out on.
But is there a way to automate modwheel and pitchwheel in Qtractor?

Most synths (well, all the ones I've checked) don't have these two as automation parameters.
And I've noticed that if I record with a midi keyboard, the pitchwheel bending is saved in the midi recording.
But I don't know how to change modwheel and pitchwheel later or how to automate them without having to record it live.
Is there a way?

Harry_Krishnerd
Established Member
Posts: 4
Joined: Sat Dec 23, 2017 1:14 am

Re: Qtractor - automate modwheel and pitchwheel

Postby Harry_Krishnerd » Wed Mar 27, 2019 5:18 pm

Open your clip in the editor and change the values in the type & parameter tabs.

ie, for the mod wheel: {Note On} {Cotroller} {1 Mod wheel}

thebutant
Established Member
Posts: 135
Joined: Sun Nov 18, 2012 12:59 pm

Re: Qtractor - automate modwheel and pitchwheel

Postby thebutant » Thu Mar 28, 2019 10:01 am

Ah, thanks!
That's very helpful. :)


Return to “Recorders & Sequencers”

Who is online

Users browsing this forum: No registered users and 1 guest