hey, does anyone know if this is possible in Ardour 5.11?
https://www.youtube.com/watch?v=B0DKjABQ6MA
I trying to do the very last part where it selected a section in Ardour. What is going on there?
Is that not available in Ardour? After all, the editor of Mixbus is Ardour isn't it?
Ardour and Mixbus 32c automation
Moderators: MattKingUSA, khz
- funkmuscle
- Established Member
- Posts: 2808
- Joined: Mon Jun 02, 2008 2:30 pm
- Has thanked: 131 times
- Been thanked: 33 times
- sysrqer
- Established Member
- Posts: 2525
- Joined: Thu Nov 14, 2013 11:47 pm
- Has thanked: 320 times
- Been thanked: 153 times
- Contact:
Re: Ardour and Mixbus 32c automation
I came across this myself the other day, from looking on their forums the video is out of date and you have to use 'r' to select the range mode, select the range and then press 'd' to go in to draw mode to move the selection. I don't know why they don't make range and draw modes some kind of smart mode.
- funkmuscle
- Established Member
- Posts: 2808
- Joined: Mon Jun 02, 2008 2:30 pm
- Has thanked: 131 times
- Been thanked: 33 times
Re: Ardour and Mixbus 32c automation
thanx man.. will try!sysrqer wrote:I came across this myself the other day, from looking on their forums the video is out of date and you have to use 'r' to select the range mode, select the range and then press 'd' to go in to draw mode to move the selection. I don't know why they don't make range and draw modes some kind of smart mode.